Model TAC & THP
Through Wall & Window Mount
Air Conditioners & Heat Pumps
Introduction |
Digital Controls, Painted Carbon Steel or
304 or 316 Grade Stainless Steel Cases,
Power Cords & Advanced Refrigerant
Systems with optional Heresite Coatings
provide a wide range of economical to highly
advanced
solutions for your application!
Economical or Smart Controls permit easy
low cost operation or advanced diagnostics
All Units are available with Painted Steel,
304 or 316 Stainless Steel Cases & Chassis...
All Units feature a flexible power cords for
easy installation and quick unit service
Advanced condensation control
greatly reduces dripping water
Units with Smart Controls have alarm outputs
and refrigerant system charging ports
|
Bebco Model TAC and THP Explosion-Proof Window Units with Eco Cool™, Eco Pump™, Smart Cool™, and Smart Pump™ Control Interfaces are self-contained through wall hazardous location air conditioners and heat pumps with all necessary components to recirculate temperature-controlled and humidity-limited air within a room or building.
Bebco Model TAC and THP Units are often identified as window units and are designed for industrial or highly corrosive environments. They have an exceptional range of optional features and are offered in the industry's widest array of sizes, ranging from 9,000 to 28,000 BTU sizes!
Most Model TAC and THP Explosion-Proof Window Units are available to operate on 208/230 VAC single phase 60 hertz power source, and they are supplied complete with a case, sealing gasket, slide-out chassis, support brackets, mounting hardware, and a three- to six-foot-long power cord.
Model TAC and THP Units feature two compartments. The condenser compartment is exposed to exterior atmosphere and contains the condenser coil, compressor, and a dual shaft motor that drives the evaporator blower wheel and condenser fan. The evaporator compartment is sealed from exterior atmosphere, and contains the evaporator coil, blower wheel, grille assembly, and electronic controls. In full compliance with all applicable EPA Standards, cooling is achieved using R-410a refrigerant.
The case, chassis, support brackets and mounting hardware are available in zinc coated steel with a baked enamel finish or optional 304 or 316 stainless steel materials. Optional urethane case coatings and Heresite® brand coil and refrigerant tube coatings may also be selected for corrosive environment protection.
Eco Cool™ and Eco Pump™ Controls are intended
for unclassified or pressurized rooms or buildings,
and provide temperature setting displays, easy
adjustment of cooling and optional heating
set points in a very economical manner!
Smart Cool™ and Smart Pump™ Controls are
intended for Class I, Division 2 Group B rooms
or buildings and provide full control of all essential
set points, a red flashing alarm screen, remote alarm devicecontacts and complete performance diagnostics! |